Water Heater Service & Tools

WaterHeaterParts.com supplies the following installation and service kits. 

Gas Installation Kit

Water Heater Tools

This kit contains all the parts needed to install a gas water heater:

  • Two (2) 15” long flexible water connectors;
  • One (1) 15” flexible gas connector;
  • Two (2) ¾” pipe connectors, 7/8” diameter;
  • One (1) female gas fitting;
  • One (1) male gas fitting;
  • One (1) 5’ Teflon® tape.
Click hereto view and purchase the gas installation kit.

 

 

 


Electric Installation Kit

Water Heater Tools

This kit contains all the parts needed to install an electric water heater:

  • Two (2) 15” long flexible water connectors;
  • Two (2) ¾” pipe connectors, 7/8” diameter;
  • One (1) 5’ Teflon® tape.
Clickhereto view and purchase the electric installation kit.

 

 

 

 


Plumbers Tune-Up Kit

Water Heater Tools

This kit contains new heating elements and thermostats that will restore the water heater to factory performance.  This kit includes:

  • One (1) copper sheath, low watt density heating element, 12” long, 4500W/240V, screw-in flange with gasket (alternate rating 3500W/208V)
  • One (1) copper sheath heating element, 11” long, 4500W/240V, screw-in flange with gasket (alternate rating 3500W/208V)
  • One (1) WH9 single-pole, single-throw (SPST) lower thermostat without electric cut-off (ECO)
  • One (1) WH10A single-pole, double-throw (SPDT) upper thermostat with electric cut-off (ECO)
Click here to view and purchase the Plumbers Tune-Up kit.

 

 

 

 

 


Pipe Nipples


Water Heater Tools

Our pipe nipples are galvanized steel with a dielectric polymer lining to reduce anode depletion or available in brass.  They are 2” to 4” long with 3/4” to 1-1/4” NPT threads. 

Click here to view our available pipe nipples.

 

 



Heat Trap Nipples

Water Heater Tools

Our heat trap nipples are galvanized steel with a dielectric polymer lining to reduce anode depletion and a heat trap to improve energy efficiency.  They are 2” to 5” long with 3/4" NPT threads.  The silencer heat trap uses rubber flaps to prevent heat loss to plumbing lines without the noise of ball-type heat traps.

Click here to view our available heat trap nipples.

 

 



5” Heating Element Wrench

Water Heater Tools

This is a 1-1/2” heavy duty element wrench that fits all screw-in type residential water heater elements.

Click here to view and purchase the element wrench.

 

 

 

 

Desktop view | Switch to Mobile

A.O. Smith © 2014 www.WaterHeaterParts.com All Rights Reserved.